Ignition ICM2 Encoder Visualization

For the ICM2, the encoder visualization screen can be accessed by going to “Setup and Testing” from the Ignition Home screen, then clicking “Encoder Position / Cam Information”.

This page shows the position of the encoder (camshaft position) and the saved zero point. It can be used to see if the reference cylinder is on the compression or exhaust stroke, and also can be used to see if the calibration was successful (if the red lines are aligned then the flywheel position should be at or near TDC).

If the ICM2 has to be removed for maintenance, this screen should be used beforehand to set the engine at TDC of the compression stroke of the reference cylinder.



Feedback and Knowledge Base